throttle

Hi all, I have owned my 2008 Seadoo Speedster 150 for a few years now but recently found that the shifter lever was completely stuck. Not having enough time, I took it to the local seadoo mechanic who freed it all up again; however, I now appear to have no 'lock' to prevent the forward/reverse...

I had my 96 Spx on the lake last weekend and it was running great for about 20 minutes, no trouble accelerating or maintaining speed at high rpms. I adjusted the trim a few times and it ran great for another 5 or so minutes and then the engine just died completely, no bogging, just off. It'd...

I recently had the shift handle on my 2012 230 SP snap off in my hand. Upon removing the trim, I discovered that the vertical lever broke just below where it inserts into the horizontal handle. Since it is a cast part, there is really no way to repair it.....and because there is no source to...

I like OEM...but the thumb needs to go on my wifes ski. I really not liking the look of the "bike" style throttle control on the market. Id like to somehow slide the thumb one around so it will be a finger one. But it will bot match up to the handle bar boot then. Has anyone seen or found a way...

Hi All! Bought a 2012 Challenger 180 SP a couple of weeks ago. About 225 hours on the boat, supercharger clutch was redone at a dealer around 178 hours. Overall, the boat starts easy, seems to run mostly well. However - I've noted that when moving from idle to full throttle (or close to it)...

Just got the boat this season and on my 3rd trip out last weekend pulled the boat out everything seemed good till I gave it throttle and at about 3,000 rpm the boat just revs out and I am not getting any power. Both throttle cables are hooked up but on one there is a 2nd cable that was not...

Hi all, I am new to the Seadoo family and forum. I have recently purchased a 2006 Seadoo Utopia 205 SE, it has twin rotax engines at 310HP. The problem I am trying to solve has to do with my throttle. On the lake when I am near full throttle (around 40-45mph), my Seadoo's right engine RPMs...

Got a 2003 Seadoo GTI LE RFI from a friends family who had purchased new ones. It had undetermined issues, but had been garage kept whole out of the water and is physically in great shape. Recently installed a reman engine from SES. Also replaced the starter and starter relay, coolant temp...

Mine has stopped working and I have spent the last 3 weeks finding a replacement. Seadoo / BRP has discontinued them (of course) Part number replacement for Seadoo / BRP 204470631 Low Speed Control Sensor Ass'y Mouser Electronics P/N 93459065-1-S-02-A $4.10 (8.4mm sensitivity) your choice...

The throttle handle on my boat is loose. Meaning I have to constantly have my hand on it when I have it on low to medium throttle. Otherwise, it "falls" back down to idle. Anyone know how to tighten it up so that it won't do this?

Hello everyone. Im new to the forum and new to the whole jet boat/PWC world. I picked up a 1997 seadoo speedster 2 weeks ago and of course everything worked when I went and looked at it. Today was the first day I took it out and ran into some weird problems My starboard throttle revs to the...

1997 Sea-Doo SPX, This issue started after I removed the two carbs and cleaned them and replaced the gray hoses. Got everything hooked back up, but when I bolt the carbs back to the engine the throttle cable sticks. I've replaced the throttle cable since it was a little frayed. The carbs and...

My RPMs are hanging around 3500-4500 around the dock. When you take it out it runs good but at low speed like around docks and putting the boat on the trailer the RPMs Hang and wont die back to idle speed. I adjusted the throttle the day before it had went limp by tightening the screw. But i...

I have a 99 GTX RFI. The throttle lever is loose. Meaning I can squeeze it to the handle and when I let go, it doesn't return all the way back to its home/in position. It also only pulls the throttle lever in the engine a tiny bit. I'm assuming I can adjust/tighten something on the handlebar...

We purchased a 2008 SeaDoo Utopia 205 SE 430hp last month. My throttle has always seemed a bit stiff, both in forward and reverse, but a couple of days ago, I guess the stress on the handle proved too much and the throttle/shifter handle broke in half! I went online to see about buying a new...

Hello, So I just bought a pair of Seadoo's in June, my first. I'm a car guy in general (VW and Dodge/diesel) so mechanical work is not intimidating to me, especially after working on a VW made after the year 2000. However I am new to carburetors and 2 stroke motors, but find them fascinating to...

First off thanks for all you help to come. I have this GSX now for 3 years. I have changed the gray fuel lines to true black fuel lines. I have removed the small filters in the carbs and cleaned and rekitted the carbs. I have an inline filter along with the factory water...

I am the happy new owner of a Seadoo jetboat !!! I bought a 2000 Challenger 2000 a few months ago, with the 240 EFI engine. Engine is clean and runs great (previous owner had it running on the hose for me). Hull is in nice shape. Colors are faded, but having it buffed and polished next...

so i just bought a 2004 seadoo sportster!! :) the boat is in great shape and im very excited to use it in the spring! i was just at a boat show and a guy told me the shifter should move easily and freely. well my shifter doesnt move at all, im scared ill break it! right now the battery is out...

Hi there, I'm new :dupe: here and am having issues with my 1995 Seadoo GTX 3 seater. I'll try describe the best I can below. It runs fine and has for some time but when you go full throttle from start it guns and goes to take off with all its might then seems to choke, as though its not...