fuel

I was working in the engine compartment and leaned up against something and heard a pop. Much to my dismay I broke off a fuel barb fitting. How bad it this going to be? Do I have to replace the whole fuel pump or anyone know how to repair this. I think it's a fuel vent line but not certain...

I'm new to fuel injection a 2 stroke usually if I have a jet slot that won't idle I clean the carb , but I'm kinda stuck on this one has a lot of electrical components and everything. Anyways have a new toy been sitting for a year or so at first would bog down and wouldn't go past 2500 or so rpm...

Hi, I would like to attach a GFS10 Garmin fuel flow sensor to my Utopia 185, and connect it through the NMEA2000 network to my GPSMap536S. The specs for the GFS10 state that it will not work with a fuel injected engine that has a fuel return line, makes sense as the fuel flow would be...

I have a rebuilt 787 that I have installed back in the hull of my 1997 xp. There are several hoses and cables that I did not remove and I am absolutely clueless as to where they belong! Please help!!

New to forum and pwc. 2nd year of 2007 4-Tec model. To start year changed oil and filter with no apparent problems. Started up for a few seconds before putting in water and seemed to run fine. Put in water, started fine, then quit. I changed the the two fuel filters with no change(no small...

Just picked up a 1997 XP last week, my first jet ski so i'm trying to get up to speed. This forum has been a great help so far so thanks to all contributors. The first time I put it in the water I had a problem with acceleration, getting to speed very slowly topping out around 30 MPH with...

Hi, when I snap on the lanyard, the Seadoo starts spraying gas out the top of the tank. I am assuming this is normally to start getting fuel pressure to the engine. Anyone ever had this happen to them? Is this an easy fix like just tightening something or do I need to replace the pump...

So I put my 95 xp in the water for the first time after it sitting for 6 years. I have replaced the fuel am oil lines and it was running great and then started having issues it would only go up to about 4000 rpm for a while. Then it would t even go to 3 now it's worse cj checked the fuel filter...

Recently bought a 97' GSI and on the way back to the boat ramp, it stalled for the first time when I was full throttle. I restarted and went half throttle the rest of the way back. I noticed their was two stroke oil that leaked in the Hull, and that the reservoir cap/hose in the hull was...

1995 Seadoo GTX 1997 Seadoo GTS carburator rebuilds Dont beleive wht they say...!!! If you buy a ski don't take anything to heart from previous owner he told me he had just rebuilt carbs year before so I spent last two years owning this ski replacing all lines and fixing problems while...

Ok I have a 1997 GTX that has had the carb rebuilt and all new fuel lines installed. Just fix oil leak issue and had an issue with the ski not starting. After checking the electronics (all checked ok) I moved to fuel and when I try starting the ski so much gas gets to the plugs they will not...

My 2005 GTX 4-tec gas gauge quit working showing full or 3/4 full all the time. I put a new OEM sensor in the tank and still have the same problem, although while the pump was out and testing the sensor, when the arm was raised all the way up, as in a full tank of gas, the low fuel light and...

Noticed my ski is having some sort of a fuel issue recently. When I first drop it in the water it will do 30-40mph then after one good speed run it seems to bog and not want to do more than 20mph. I replaced the spark plugs, put a fuel system cleaner in and fresh gas and it is still doing...

Hi Guys, I bought 3 second hand gauges for my 2003 Sportster LE 951 carb boat. The Speedo and Rev Counter wires matched perfect and work a treat however the Fuel gauge wires are different :mad: My original fuel gauge has 5 wires: 1 x black 1 x pink 1 x light purple 1 x light blue 1...

I have a 2001 Islandia w/Mercury 240 EFI M2. I was running for about 20-25 minutes at approximately 35 MPH when the engine just shutdown. I came to a complete stop, placed the "gear shift" in neutral and attempted to restart. Engine turned, attempted to "catch", but never fully caught. I...

Hey Everyone, I have a 96 GTI dual carb. I just installed and broke in a new SBT motor. While I had the motor out, I cleaned the carbs and re-set the low speed screws to factory (1 1/4 turn out i think?). I replaced the spark plugs after the break-in process. I am on my second tank of...

I have a freshly rebuilt 951 that wont accelerate to full revs. I am thinking that it is not getting enough fuel. Out of the water and connected to the hose it revs freely enough ( not to high as it is still tight and needs running in ). On the water , under load it starts to accelerate , then...

I am just looking for the size and thread of the cap. i cant tell if its a 1.5" or 2.0" line, and if the thread is 12. i have spent over 1.5 hours online and apparently i am just too dumb to sort this one out. i dont want to buy the wrong size obviously. Need to order asap so i have it by...

Hi everyone: I have a Challenger 1800 with twin ROTAX 787's and I'm running into a problem were i'm missing the RPM range between 1500 & 4000 on one engine only. Symptoms are as follows: WHEN COLD - Engine starts and idles fine at around 1500 - if i increase throttle it slowly creeps...

Good Morning, I have a few questions that I hope a tech or someone else could answer. I have a 1996 Challenger and believe the "Fuel Baffle" (P/N 204560071) is the reason I am not getting any fuel to the engine. I cannot find an actual "fuel pump" in any of the drawings. I noticed in a...