1995

95 717 XP will not power on at all, completely dark when pressing non DESS post and start button Key post has continuity when pressed Engine turns over when shorting solenoid Replaced MPEM, solenoid, stator, and rectifier to no avail Fuses are good

I recently bought a Seadoo XP with a 657x engine that is non-running with no spark. The previous owner said they saw smoke come from the MPEM and so I ordered a aftermarket one that’s compatible with part 278-000-070 (For 587 engines or 92 XP from sellers page). In my jet ski it is part...

Ahoy SeadooForum, This build thread serves to archive the trials of my first water craft, a ’95 SPX. It was purchased in March 2022 with a known issue of fuel not getting to the carburetors. I am a first-timer at fiddling with two stroke engines but find forums a wealth of info, so here I am...

Hi there, MPEM is toast on my 95 and as you know impossible to find. I saw in another post it is possible with the 657x engine to swap an MOEM with a 95 657x PWC. Would anyone have any ideas how exactly this could be accomplished? I just purchased one off eBay but would like to make sure that...

Been fighting this unit all summer, and I am about ready to throw in the towel and scrap it. At this point, the engine will start and run fine on the trailer (no hesitation, no bogging), but on the water it bogs badly at and above 1/3 throttle, in fact the RPM does not increase at all through...

After taking my 1995 SeaDoo HX out for the first time, and thinking about other friends wanting to ride it, I am Interested in buying a rear stabilizer platform for it. I have been looking around and cannot seem to find anything. Does anyone know where I should be looking for something like...

Hey guys! I've got a few questions to start with and potentially more to follow. I have 1995 GTX thats been in my family since it was purchased new. It just got a remanufactured SBT engine that I installed, as well as the carbs rebuilt, which I also did. Took them to a semi-local shop to...

Here's some pictures of my seat job. I was able to buy just purple parts that were in bad shape since I bought the boat a decade ago. Got the pieces for $190 with shipping off ebay. I used 3/8" staples with a $20 electric stapler from harbor freight. I didn't do the front upper portion yet...

Ski has a dead starter, owner fried it from it constantly cranking, solenoid fried too, I put a new solenoid into it and it clicks again, doesn't turn over because I know the starter is dead. As soon as the key is attached (pre DESS) the solenoid clicks, and is constantly getting energized, pull...

I have a 1995 Seadoo XP that im parting out. I obtained the ski with no title and i have too many projects going on so i really just want it gone. It's powered by the 720. If you need any parts feel free to comment or pm me. I know the stator is bad. All the electronics are in decent shape aside...

I have a 1995 sea doo sp that I inherited from my grandfather, it’s been sitting about three years and I’ve been trying to get it running this year. I’ve rebuilt the carb, replaced all grey fuel lines, cleaned the fuel filter, put new spark plugs in and new plug boots on the cables, and a brand...

I just bought my 1995 SPX and when I take it out of the water there is about 1 inch of water in the bottom of the jet ski that will not drain through the drain hoses. I have to take a rag and sponge it out. Cant figure out where it is coming from. I run the jet ski on the trailer in the water...

So the other day I was riding with my friend, he was on a 95 XP 717. All of a sudden it started vibrating like crazy over 5000 rpm. After looking it all over, all of the engine mounts are broken and the engine is literally sitting in the hull attached by the drive shaft. So as the only option...

Hello everyone, I am new to the forum and I have a 1995 Seadoo GTX. I bought the ski 2 years ago from a guy who has owned it most of its life. He rebuilt the engine right before I bought it. The ski runs awesome with no issues until yesterday when i was on the water. I am pretty sure the...

Some of you already know that I own two garage-kept, yet slightly abused (forgotten for 6 years) '95 SeaDoo XP's (720cc). Though I have another active thread about a bogging mechanical issue (on, now both of them) I figured I would also work on the minor electrical issues and such. Here's what...

I have a 1995 speedster and the reverse kind of works. I like to hear from people who have this boat or has own this boat. on how well the reverse worked on there boat. It seem that the one jet pump sportster work better. This one works somewhat but not good Please note all checks with reverse...

First, thanks for hosting such a great forum. I am thrilled with being a member and grateful to all those who have helped the SeaDoo community. I will admit that I have not become familiar enough with the site to conclude that I have done a full, exhaustive search on my problem before...

Just bought a used 1995 gtx seadoo even though it looks stable and secure , the hose that is attached with the two clamps to the seal carrier spins when I turn the engine on. Is this OK? I attached a photo from the manual about what hose I am talking about

I took out boat for first time. Ran it only on one engine. Ran fine for about 2 hours. Stopped for about an hour. Tried to run it again. Ran both engines. Immediately, a continuous beep (alrarm type sound) started. We tried putting in reverse to see if it had something stuck in it...

Hey Guys – long time lurker, first time poster. I've been restoring watercraft for a while, but never shared on the forums. Starting a new project I thought you guys might find interesting: two 1995 XP 800s. I have a lead on a third 95 XP 800, but it’s 400 miles from my house, so I’ll be...