speedster

Help! My 2008 Speedster 200 (430) isn’t beeping or starting. I found the one rectifier completed shot and replaced it but still have the same issue. If that rectifier went bad, what other components could of been effected? Does anyone have a wiring diagram?

Hi I'm a brand new Speedster owner and new boat owner too, but today out on the lake the pin that holds the ladder in (when the ladder is deployed) came loose and was lost. From the seadoopartshouse website, I don't see that the pin is available for sale. And I don't see if parts 5 and 6 are...

Starter replaced fixed problem

Hey guys, long time lurker but first time poster. I’ve had an issue with my 2004 Speedster 200 since I bought it (in 2009), where the Starboard (right) engine is slow to crank/start. Well, slower than the port engine. We would always start the port engine first, then the right engine would...

I need a reverse gate for my 96 Speedster. It is for the right side. I need to replace the one I broke off. Part #204170008 Can anyone help me out!!! Thanks

I have a 2012 Seadoo Speedster 150 HO. Here is a pic of a connector and I am trying to determine what sensor that it goes to. It is above the Deutsch connector for charging near the throttle body. The reason that I am trying to identify it is because I recently found the wire connected...

Took the “New” speedster for its first water test today and the starboard side motor ran perfectly but the port motor would die out at times and not really rev up easily, pulling the choke would help at times and other times it wouldn’t. I took it home and pulled the carbs apart and checked...

Hello all, Got a new to me 95. I pulled the Jet and driveshaft to replace some seals, etc and to service the pump oil. I noticed there is only 1 tube coming from my Jet housing and I see other ones with 3 tubes. The mounting plate also only has 1 hole for the tube. Is this normal for this...

Hello all, Got a new to me 95. I pulled the Jet and driveshaft to replace some seals, etc and to service the pump oil. I noticed there is only 1 tube coming from my Jet housing and I see other ones with 3 tubes. The mounting plate also only has 1 hole for the tube. Is this normal for this...

Motor was supposed to go into a 95 Speedster and all the assembly parts were taken from the boat. The reman core has never been started and was purchased with the SBT complete gasket kit and break-in oil that will come with it. Still have all original purchase reciepts as well, however, the core...

I bought a 95 Speedster a while back and got it running. Now after it not using over winter, it is not doing anything when I press either starter button. When I got the boat I noticed that it had a common problem of one of the MPEM fuses constantly blowing, but both motors would crank fine. One...

I know everyone has been complaining, including myself about the seats on the 98-2001 speedsters with no real replacement.... until now! Check out the Brand New 1998-2001 Seadoo Speedster Seats for my 98 Speedster! No more cracked / faded / embarrassing seats! What do you guys think???? More...

Happy New Year everyone. Quick question... I'm looking at buying a set of mats for my speedster. I noticed the engine cover is different on the 1996 Speedster vs the 1997 Speedster and the mats are different. The 1997 mats do not have the large pieces that cover the sides of the cover like the...

$5500. 1996 seadoo speedster jet boat well maintained. first off it has 257hrs on the ecu engines run time log checked by watercraft direct in costa mesa. this model came with dual 717 rotaxengines. with that your getting 718 cc's getting you 170hp. the upholestry is perfect and new. two new...

First off, I would like to thank everyone on this forum as I have done a ton of trial and error after reading the available posts/threads on this exact topic. I have a 2001 seadoo speedster with 240 EFI. The oil tank is on the port side of the engine if that helps determine which engine version...

Hi Everyone, 05 Speedster 200 (Supercharged Twin Engine). My Right side engine revs up and will barely move the boat as of today. It will rev ALL the way up with normal throttle. Also I see a bit of oil coming from an area shown in photos. Any suggestions? I know essentially nothing about jet...

$4500 OBO 1998 SeaDoo Speedster Jet Boat w/ Trailer. 16’ twin engine (2 stroke Rotax 787) totaling 220HP. Mechanically a sound boat, both engines start right up and run just fine. Port Engine: When I purchased this boat the port engine was inoperable. I did a full rebuild on both of the...

Hi Everyone, I live in Colombia (South America) and was recently offered this Jet Boat. I am looking for a trailerable boat to be used in lakes and rivers at high altitude (2,600 meters or 8,500 feet above sea level) They are very hard to come by as they were not readily available so that is...

I am posting this for those that do their own engine winterizing and find it is a pain to hold the mechanical throttle to WOT when it is time to fog the engine. That was exactly my scenario this weekend, my 2010 Speedster is tucked into the corner of my garage and getting access to the...

I have a 1998 Seadoo Speedster with twin rotax motors. I have no clue what motor size they are, or what carbs to get. There are dual carbs on both motors. I need to replace the passanger side carbs. Are these 787, 717, 720...? Help me please lol. I need to know the correct carb size for mag and...