sea doo

Howdy folks, I have a 1997 Sea-Doo Bombardier GSI that has recently been giving me some pain. After a lot of trial and error, the issue has been narrowed down to a dead ECM/MPEM Problem is, I can’t find a replacement one anywhere! Apparently this specific model is extremely hard to find and I’m...

Hey everyone I picked up a 1996 seadoo gti, I rebuilt the jet pump, changed plugs, battery, all of the regular maintenance so that I knew when it was done. The ski was running great until about a week ago I was on the water and it was loosing power. I figured the only thing left I didn’t do was...

I posted a thread of objective problems we've experienced with our new Fish Pro immediately preceding this one. Here are some subjective comments about our ownership experience so far: The Seadoo cover is very nicely designed, high quality and versatile. I was reluctant to buy at its high...

Good afternoon fellow rippers! New to this forum... I have a 587 SP that lost compression. I have an XP 717 ski lined up to buy to do an engine swap, just trying to get as much info as I can on what I need to do it/ if it's even possible. The computer is bad on the 717 so hopefully thats not an...

i just purchased a new to me 2018 RXTX 300 In green and so far im loving it. Its my second ski, my first being the 2013 GTR 215. I noticed that there is a lot of play in the handle bars and i thought that it had something to do with the adjuster. Then the other day i was jumping it out the water...

Looking for a hydraulic trim system for my 96 XP and possibly one for my 96 HX if one is out there. Thanks, Chris

Hey everyone I got a 1994 sea doo xp with 657 twin carb. Rebuilt carbs new needle and seat adjusted HIGH and LOW screws on carbs started up fine but went to go put it in the water and wouldn’t go over 4000 rpm and wouldn’t start again.... any input is appreciated thanks!

Hey everyone I just picked up a sea doo 1994 do with the 657x engine in it. Bought it from a guy that said it was sitting for about 2 years and was garage kept and had it winterized. Compression is good engine turns over great pulled the carb off (twin carb) installed new gaskets jets were clean...

Hey everyone I just recently picked up a 1994 sea doo with the 657 motor for a steal and has really low hours on it and hasn’t ran in about 2 years. I did a compression test on it and bothe cylinders were trading 150psi. Now I installed the spark plugs back into the cylinders and attempted to...

2017 Sea-doo RXT 260 With trailer and cover. 168 hours. New IBR. $11.995.

Regrettably added a cup tap water to my coolant system to top up as it was low. Instantly realized this was a poor decision. Just wondering if I should flush the system and put fresh coolant in before going for another ride or if I will be ok since it was such a small amount. Cheers.

The jet ski runs perfect for 5-10 min then it starts to act up. Dies randomly and will start but turns off after 1-2 second. C The gauge also starts to run slow when this starts happening. I have replaced the fuel pump also I replaced rectifier. I have heard maybe a stator? Any help would be...

Hey everyone so I got an issue with my 1996 sea doo GSX 787 motor. I keep getting water into my hull and I had already replaced my carbon ring and the VTS boot on the jet pump due to it being torn. I checked the exhaust cause I know that they are somewhat known for cracking and didn’t seem to...

I overfilled my 2005 sea doo rxp with way too much oil and I took it out to the water it ran good for like 10 min then the oil light came on and the cluster said oil and it was in limp mode after that I took it home noticed I had overfilled it by a lot no water was in the oil I got the level to...

This may be a stupid question but it's driving my ocd nuts.. Why is the seadoo challenger 180 decal in different spots on right and left... Mine is with the custom decals. Thing is, mine were removed by the original owner but left a mark so I wanted to put them back on. While installing them I...

Guys I need help please it’s a 2000 seadoo gtx 951 with the carbs when I push the start button the starter sounds like it wants to start but it gets stuck right away.

I have a 2013 gtr 215 that just got the carbon seal replaced it seems to be pressed to hard against the driveshaft support ring, on first fire up carbon ring I believe started smoking and was extremely hot. How would I adjust tension on ring (the driveshaft support collar is boiling hot when...

Motor was supposed to go into a 95 Speedster and all the assembly parts were taken from the boat. The reman core has never been started and was purchased with the SBT complete gasket kit and break-in oil that will come with it. Still have all original purchase reciepts as well, however, the core...

Bought the boat for really good price knowing it was going to need some TLC. Had a blatant fuel delivery issue as fuel was pouring out of throttle body. Pulled apart and found lines going into fuel rail were disconnected and a couple other little things inside that lead me to believe someone had...

My 2016 RXP-X 300 sheared off all the flywheel bolts, destroying the stator, flywheel cover sending filings from stator which look like fools gold thru-out the engine. So being my machine has 115 hrs I'm being told Sea Doo most likely won't cover anything. This is a defect in the Sea Doo...