Jasonv
Active Member
Is the mount welded to the umi?
how much of the front tub do you cut out to get that tank in?
Is the mount welded to the umi?
The original pisser is 3/32" and that is 3/8". I'd leave the pisser alone and just get a 1/2" X 1/2" X 3/8" T to source the flowing water from the outgoing hose fastened on the left rear of the head. Normally it would have incoming water there but yours has reverse cooling.
I used an angle grinder lol then cleaned it up with the bench grinderIve got a plasma cutter if you need to cut some shapes out
The plasma has greatly reduced how often I go buy cut off wheels, it will pay for its self in the next 20 years:facepalm:I used an angle grinder lol then cleaned it up with the bench grinder
I used an angle grinder lol then cleaned it up with the bench grinder
Ive got a plasma cutter if you need to cut some shapes out
How far from sml are you?
Stainless I had a strip left from a job in a restaurant
No, doctor says I need to be at SML more, even if its fridgid, so I might take my crazy ass up there this weekend. I was thinking you are closer, Im 1.5 hours from my house to the penhook public ramp. Typically I go ride, then look at the weather.