usafaux2004
New Member
Hey folks, I'm thinking I need to do an alignment, but had some questions. I've seen the $150 set sold by sbt, but I've also heard that you may only need just the alignment tool.
Are there alternatives to get just the alignment tool? Could I make one? I have a lathe in the garage, and can make it. Does it have to be as long as it is? A buddy has the sbt tool, and it's almost as tall as him.
Thanks all,
Mike.
Are there alternatives to get just the alignment tool? Could I make one? I have a lathe in the garage, and can make it. Does it have to be as long as it is? A buddy has the sbt tool, and it's almost as tall as him.
Thanks all,
Mike.