Must have tools

[etemplet]

Any luck yet?

I am assuming the drawings of the parts are for personal use.

On a side note, I wish the fit for the long alignment shaft were tighter than it is. Perhaps one day I may install some bushings but I guess for practical purposes it's close enough. Good Luck.

My personal disclaimer... I assume no responsibility for the accuracy of said drawings and I know my 4's look like an "A" to some people.

 

[codfather]

Yes its for me personally as per above I ordered the parts from the States to South Africa but they couldnt ship the large pole due to cost and I actually misplaced the other 2 pieces that go into the back of the engine.

 

[etemplet]

No problem... the email is on the way. If you need to clear anything up just let me know. That one small piece would be a pain to get the bore size spot on. It is also tapered which is just for entrance I am sure. Good Luck.

 

[Mekanix]

Hi Mekanix
Thanks for the favourite tool list....I have half of the pump alignment tool however due to shipping costs I cannot get the other part....Is their any chance you could measure the parts with the red cross so that I can have them manufactured here in South Africa?

Sooo sorry, Just saw this now, I don't know why i didn't see it before.

Looks like the guys have you sorted out though.

 

[codfather]

Sooo sorry, Just saw this now, I don't know why i didn't see it before.

Looks like the guys have you sorted out though.

Thank you.....Yes sorted when I convert to Metric ....Awesome help from this Forum.