Doing the pistons on the 800/787 engine. It was in original state until now, still had the original cageless pin piston pin bearings. Obviously that had to go so i'm into a caged set now.
Might be a stupid questions but do I use the original spaces, (metals rings that were at the end of the pins) or just the caged bearing alone? Lots of space with just caged bearing.
any help greatly appreciated
thx
Might be a stupid questions but do I use the original spaces, (metals rings that were at the end of the pins) or just the caged bearing alone? Lots of space with just caged bearing.
any help greatly appreciated
thx
