Oh_dannyboy85
New Member
Hey everyone!!
Have a bit of a strange one with my 2010 rxt 260 rs.
Was riding the other day bout 100 kph or so. Was feelin good,
Slowed down to an idle then tried accelerating again.
Engine light and warning beep occurred. Limped back to the ramp.
Even when flushing out light was still on.
Seems to me that could be a connection issue as it did it previously
On the same ride. I can't find any info bout the code or a fix.
It's code P106E. I think I had dtc for the throttle sens as well which would
Explain limp mode. I read somewhere they had issues with cleanliness of throttle body.
Removed and cleaned that. That code is now gone and can rev but not smoothly.
Previously it has had a map sensor replaced.
Has anyone heard of an issue with this or can elaborate on the code?
Thanks in advance.
Cheers. -Dan
Have a bit of a strange one with my 2010 rxt 260 rs.
Was riding the other day bout 100 kph or so. Was feelin good,
Slowed down to an idle then tried accelerating again.
Engine light and warning beep occurred. Limped back to the ramp.
Even when flushing out light was still on.
Seems to me that could be a connection issue as it did it previously
On the same ride. I can't find any info bout the code or a fix.
It's code P106E. I think I had dtc for the throttle sens as well which would
Explain limp mode. I read somewhere they had issues with cleanliness of throttle body.
Removed and cleaned that. That code is now gone and can rev but not smoothly.
Previously it has had a map sensor replaced.
Has anyone heard of an issue with this or can elaborate on the code?
Thanks in advance.
Cheers. -Dan