Hey, at the end of last summer I had a pretty bad issue where I broke my drive shaft, Pto, and carbon seal. I ordered the parts from someone on here but didn't get them till middle of winter after I had alerady winterized it. So I just left it until now.
I have a new Pto, drive shaft and carbon seal, I was just wondering if there was anything else I needed? From the schematic it looks like there's a lot of seals. Do I need each seal? Or is there a way around that to just make it work?
I haven't even checked the box, or what else I had sitting around since the winter so I might be wrong, but I was just wondering if there's anything I can salvage? The drive shaft is inside of the ski right now,, I couldn't pull it out because there's still stuff attached to the shaft and I couldn't pull it thru the hole yet.
also does anyone have a nice walk thru for this procedure?
I have no experience other then taking it apart last summer. I also opened the jet pump bearing? cause someone told me to check the oil, it was all good but a bunch leaked out cause I didn't close it properly with the little ascrews. Is there a trick for that?
I have a new Pto, drive shaft and carbon seal, I was just wondering if there was anything else I needed? From the schematic it looks like there's a lot of seals. Do I need each seal? Or is there a way around that to just make it work?
I haven't even checked the box, or what else I had sitting around since the winter so I might be wrong, but I was just wondering if there's anything I can salvage? The drive shaft is inside of the ski right now,, I couldn't pull it out because there's still stuff attached to the shaft and I couldn't pull it thru the hole yet.
also does anyone have a nice walk thru for this procedure?
I have no experience other then taking it apart last summer. I also opened the jet pump bearing? cause someone told me to check the oil, it was all good but a bunch leaked out cause I didn't close it properly with the little ascrews. Is there a trick for that?