• This site contains eBay affiliate links for which Sea-Doo Forum may be compensated.

Pressure regulator on Muffler

Status
Not open for further replies.

97explorer717

Active Member
I had already bought the bellow and little clip. Good thing I did as it was roached out BUT the spring is broke. Was not expecting that. I was wondering if a rave spring was the same or would work with no adverse consequences? I see they're different part numbers so I'm guessing no. If no where can I get one shipped quick? Also could I temporarily run it without the spring? The waters calling!
 
The spring for the water regulator is made with larger diameter wire and is a lot harder to squeeze then the RAVE springs. It's not going to run right without it. If you do run it then at least put the two broken pieces of spring back in there until the replacement one comes in.
 
Status
Not open for further replies.
Back
Top