For the gen 2 ibr what is a good replacement for the 775 motor, also what are the specs of the original ?
I've noticed the wire size for the oem motor is larger than the ones I was replacing it with. So I'm guessing it's a low turn count, high speed motor but I'm not sure what the spec rpm would be at 12v. There's just too many options out there.
I do know that the wrong or slower motor will fail calibration and I've instead of replacing motors I just replace the end bell and brushes on the original motor and that makes it pass calibration. But if calibration isn't an issue, any motor technically works.
I've noticed the wire size for the oem motor is larger than the ones I was replacing it with. So I'm guessing it's a low turn count, high speed motor but I'm not sure what the spec rpm would be at 12v. There's just too many options out there.
I do know that the wrong or slower motor will fail calibration and I've instead of replacing motors I just replace the end bell and brushes on the original motor and that makes it pass calibration. But if calibration isn't an issue, any motor technically works.