Start stop button / hand grip removal

[bdesim2]

What’s the easiest way to remove the hand grips to get to the start stop button. I have a ski with a bad one and need to replace it. Any tips or tricks?

Button really has to be mashed currently to start the ski. I have an entire module from another ski I can use, I just don’t want to ruin the hand grip by cutting it.

 

[mwat65]

Pop the end cap off the end of the handlebars. Unscrew the bolt and remove the hand grip. The start stop button holder has a set screw. Loosen with Allen wrench. Holding the start button in is a small philips screw .

 

[bdesim2]

Pop the end cap off the end of the handlebars. Unscrew the bolt and remove the hand grip. The start stop button holder has a set screw. Loosen with Allen wrench. Holding the start button in is a small philips screw .

Many thanks! Sounds pretty easy!

 

[mwat65]

Take note of how the keeper with the small philips screw goes in. It hold your start button in the housing

 

[DJDaveOtt]

No need to completely remove the set screw. Loosen just enough that the assembly moves freely. If you do unscrew it all the way, there is a lock nut on the inside you need to not lose.. Trust me, I learned the hard way lol

 

[bdesim2]

I was able to do this it was easy. Was nice to know the little tricks before tackling and I didn’t lose the lock washer. Mine were in there pretty good luckily