Water Horse IV
New Member
I was told my original carburetor problem is fixed and every seal within the Sea Doo has been replaced with no leak. The engine locked up on their last test drive. the shop is willing to cover all cost incurred and add a "OIL BLOCK" that will fix the problem with bottom end on engine (their words). From this point on I would have to pre mix my gas before adding the gas to my Sea Doo. I'n not thrilled because my engine had very low hours. However, I've been told this is a common fix and Sea Doo should run like new when all work is done. Is this procedure common? is this a bad thing since this model has it's own separate oil and gas compartment which aliviated the need to pre-mix
Thanks to whomever can offer any advice?
Thanks to whomever can offer any advice?
Last edited by a moderator:


