• This site contains eBay affiliate links for which Sea-Doo Forum may be compensated.

No spark 2000 gtx

Status
Not open for further replies.

jdff21

New Member
OK here is what is going on picked up the ski last year had a bad crank shaft replaced it everthing is back together and checked all wiring is correct did the light test to the white wire on the coil and does not light upwhen cranking the motor als i do not get any beeping out of the mpem enen when i do the hit the button 5 times what do i check now thanks for any help
 
Might be battery cable ends are bad, Is the small black wire connected to magnito houseing?
 
I would start by testing your beeper. If its bad go to radio shack and get a new one. I'm not an expert, but thats where I would start. That way you can do the advanced diagnosis and see if you get the long and shot beep.
 
ya will do that do you no how i can test my trigger switch inthe magneto housing to see if that is sending voltage out to mpem
 
ya will do that do you no how i can test my trigger switch inthe magneto housing to see if that is sending voltage out to mpem

breakdowns' in the manual, bud.

think you'll need to re-pull the mag cover and take a look....:banghead:
 
Status
Not open for further replies.
Back
Top