• This site contains eBay affiliate links for which Sea-Doo Forum may be compensated.

destroyed impeller!!!

Status
Not open for further replies.

Ronsse610

Active Member
so was digging through my scrap seadoo parts bin and came across my impeller that i destroyed late summer...

photo-3_zps8b4502a5.jpg

photo-4_zps73612f66.jpg

photo-5_zps1b31c69c.jpg
 
oh, it was at the end of the day too! i was pulling it out at the ramp, but because the ramp i go to is so crappy and not well built, the water being extra low last summer when i throttled to get up on the trailer i was extra low in water and i swallowed the rock, and it was so big and stuck so fast that the whole impeller actaully twisted my shaft and everythig inside the grate, all the plastics had to be changed! was a real bummer! :(
 
It's pretty bad, just a thought, you might want to contact SBT, bet they can rebuild it, send them a picture. It's not a bad idea to have one on hand, summer's too short.


Lou
 
unfortuately SBT's prices went through the roof on the exchange program. I would rather pay a few bux more and have Skat trak do it. They do OEMs.

Impros is another option, but they have the SES syndrome. Give you a date and take twice as long. They give back a lot to the PWC community though so I throw them a bone or two every year.
 
I will have to agree,, the rock did a bang up job...

When I put my skis on the trailer I do so with some speed on so that I can keep steerage and not rev the engine any more than I must do so. I have seen too many people suck crap up at many ramps...

I put the Teflon slides on my bunks and slide all the way up to the winch stop..
 
Status
Not open for further replies.
Back
Top