mejim707
Active Member
In my on going restore of this old beast I tested the auto bilge sensor about a month ago. I rang out the wires and cleaned it real well. Unfortunately it does not work. The bilge itself works using the switch on the helm and the fuse is good. I think Part #64 of the below diagram has a faulty relay or something else is wrong. Can someone confirm that this relay controls the auto bilge / sensor? Is there something else I should check? Also, are there any suggestions on a different auto bildge sensor configuration / unit?
Thanks!
Diagram: 1996 Sea-Doo Challenger, 5896 Electrical Accessories | Fox Powersports Sea-Doo Partshouse
Thanks!
Diagram: 1996 Sea-Doo Challenger, 5896 Electrical Accessories | Fox Powersports Sea-Doo Partshouse