My bow eye hook is loose and moves around. I want to tighten it but cant get to the bolts. My idea is to drill a 4" hole under the bow seat and access it from there. Is there some other way?
In the bottom middle of the engine bay there is a big seeming empty hump in the hull but it is seemingly empty. What purpose does it serve. Can I drill into it and put some screws or rivets in it?
1996 speedster
Mine also has valves on the oil lines to keep excess oil out of the motor. Apparently there are some seals in the rotary valve or the oil pump that seep over time. So I open them when I run it and keep it closed for storage. I dont know if this will result in oil in the bilge but its something...
Mine was leaking from the grommets on the bottom of the oil tank. Just wipe down your hoses real good and check them in a few days they'll probably have oil on them. They are 10 bucks a piece new.
Can anybody identify the red wire in the picture for me? It has a plug that is still plugged in in the wires are broken off I cannot figure out where it needs to go to.
The only other issue I have is my bilge pump stays on at all times with the fuse in. There are some wires coming from the...
On my new boat, on first start up the port motor ran, but very rough. I went thru the carbs and found that the fuel return was plugged on one and cleaned all jets and fuel pumps. After that it took some cranking and then ran rough for 20 seconds and then smoothed out I turned on the water hose...
Thanks! I'll check on the fuel baffle.
I did. Not rebuild the carbs with a kit but I did tear them down and inspect and check pop off.
Speedo wheel is missing! But I don't really need to know my speeds. Plus I have a GPS.
I plan on getting a few tiny tachs to keep good logs of hours and...
Ok so I picked up a Speedster over the weekend. Unfortunately neither engine runs well and I am used to Yamaha 2 strokes, So I need some help from people with experience to help me. I usually learn the hard way but hopefully you all can lend some guidance.
Left engine.
Appears to be stock...