Recent content by mrrxtx

Mag side.....there is a hole drilled in it.....don't ask....long story

I have a 2000 GTX with a very new motor. I accidentally screwed up one of the crank seals. Is it possible to (motor is out) flip the motor over on the bench and remove the bottom case and lift the crank out a bit and replace the seals like that without tearing the whole thing down. Can that be...

Bought a 2009 with some problems. All new plugs. injectors and coils. Ski runs great on land but wont go over 50 mph or so. Pulled pump and has a lot of corrosion cleaned as best as possible and impeller and wear ring in real nice shape. Wondering about supercharger ? Probably should be...

2009 RXT-X ....just purchased...wasn't running right...replaced the coils & injectors...no codes idles fine ...accelerates good.... just doesn't want to go over 55mph....Digital tach not working....Supercharger ?? Prop ?? wear ring ? where do I start. I don't know the hours or if the...

Wondering what your opinions are on siliconing a VTS box to keep water out. 2 out of 3 clips are broken and I'm planning on using zip ties to hold it closed but thinking about using silicone on it . Also should you install gasket around the VTS module or in the cover before putting it...

Had motor rebuilt 2 yrs ago...got it back and slowly put it back together when I had time. I guess I didn't tighten magneto to flywheel bolts properly because after finally get it running and in the water for a couple hours it died and kept blowing fuse in rear electric box and had 12V light...

Yes it does....after looking at some videos I can see I drilled right through the seal,,,hopefully didn't damage the crank....this sucks....motor has to come apart.

Long story how and why but I put a drill bit through the mag side crank seal on a brand new 951 motor. There is a small hole through the rubber part of seal and and I can feel the meal part of the seal with a small pic through the hole. Any chance to put silicone in hole and be ok. Or must...

Where are all you Seadoo guys.....Anything ???

I have a 2009 RXT-X and I bought it with the trim not working. I finally pulled it apart and the trim motor was all rusted and locked up. I have a new motor and I plugged it in and nothing.... fuse is good. It seems both wires going to the motor have 12v.... I unplug the big connector and...

Already bought Riva's....$89.00.....Thanks though

I have a 2009 RXT-X with a cracked resonator. I'm thinking about installing a free flow exhaust type pipe. Don't really want to do expensive Riva rear exhaust....I see guys going to parts store and using a steel exhaust tube...seems like that would rust out in no time....where to get aluminum...

It seems almost impossible to see anything in the rear engine compartment with all the hoses and intercooler....seems like I'd have to remove several of them to see anything.....then I don't think I can run it ??

Check the "charge" fuse.....mine was very corroded....cleaned it and replaced it....now charging good....

It wasn't charging...replaced corroded fuse and it's charging well now.....Now the water leak....I tilted the trailer up and closed the drains and put a hose in rear of ski to look for leaks...thought for sure it would be opas fittings....but water soon started coming out the exhaust exit.....I...