starboard engine 99' challenger not getting spark

[Menace1800]

Hi Everyone,

I'm actually new to this seadoo jet boat. I got seadoo couple months ago and enjoy taking the family out on the lake. The third time I was out, my starboard motor "cylinder 1 close to the mag" worn a rod bearing. Now I replaced the motor with a new rebuilt from sbt. Follow all the directions from the company. Now I was trying to start the motor no sparks. My port motor is running fine.

I've check the grounds, ignition coil and wires those seem to be working properly. Trigger coil is the only thing that I have not open and diagnose. I believed I have to buy this harness for testing this part.

Question is " what are the chances of the trigger coil from the mag going bad?".

Please help..
Thanks

 

[pincusa]

In switching the engine over, you might have hit something or missed a wire inside the mag case. If you can, pull the cover and make sure everything is correct.

 

[Menace1800]

do I have to pull out the motor again to do this... or can it be done in the boat.

Thanks

 

[seadooya]

in the boat..pull the front cover off, the pickup coils' right there.