Ok i have a 1993 Sea Doo XP, I am trying to remove the rear pump house assembly and made a pump puller with a 2x4 and then bolts to slowly remove the pump. I have done this and having one hell of a hard time as it is not budging or coming loose, any advice or suggestions as I am thinking of using a crow bar to help leverage or break the seal?
My next question is, does the drive shaft that attachs to the fly wheel extend into the pump house and to the impeller or is there a separate piece in the pump assembly that joins the impeller. Some guy told me that the drive shaft only goes to the pump assembly but not in to any bearings in the assembly and if the pump bearing seems to be seized that i need to replace the bearings and some expensive piece in the pump house.
All I want is to get the pump house assembly off the rear of the sea doo for starters, any advice would be greatly appreciated... Ryan
My next question is, does the drive shaft that attachs to the fly wheel extend into the pump house and to the impeller or is there a separate piece in the pump assembly that joins the impeller. Some guy told me that the drive shaft only goes to the pump assembly but not in to any bearings in the assembly and if the pump bearing seems to be seized that i need to replace the bearings and some expensive piece in the pump house.
All I want is to get the pump house assembly off the rear of the sea doo for starters, any advice would be greatly appreciated... Ryan
