• This site contains eBay affiliate links for which Sea-Doo Forum may be compensated.

Perfect combination and still not running?

Status
Not open for further replies.

desertracer695

New Member
I have a 1993 SPI (Yellow Motor), that has Good Spark, and is getting Fuel, to the plugs with excelent compression that I can not get Running??? We recently took it out to the lake and it fired right up, we rode for 2 hours with no other problems. left the lake and went to another with about 1 to 1.5 hours in between. and the thing will just crank until the battery goes dead. The plugs will be soaked with fuel, and there is good spark for the life if me i cant figure this one out. I have checked all of the fuses and they are good, replaced the plugs, checked the killswitch, teather and the start switch and they are getting power. i am furstrared and lost any advice will be helpful Thanks. Sorry the post is so long, better to do it all at once than leave people hanging :willy_nilly:
 
OK.... all sounds well.... but....


What is your "excellent" compression?

Have converted to Pre-mix?
 
Unfortunately, I havent done a true compression test, a "redneck" test was accidentally done and it blew the hat off of my brothers head without the spark plugs in. http://www.seadooforum.com/images/icons/icon10.gif I went through the electrical system, bypassing the kill switch as as well as the tether switch and still nothing i am super frustrated, as well as confused? The machine is still oil injection, NO premix
 
Checked the compression today and it was at 125. in both cylinders, The ski actually started yesterday, but this morning we were unsuccessful again, doing the same thing All the Help would be greatly appreciated!!
 
Sounds like you're flooding! Could mean a needle valve may be stuck open! If you have a pop off tester I'd check that!
 
Status
Not open for further replies.
Back
Top