Parts needed, PM isn't working

[96spxpos]

[MENTION=41828]Minnetonka4me[/MENTION], I tried sending you this msg 5 times and it's not working. So, I need these parts, can you pm me with a price, and I'll see if I can respond.
Thanks!
Hey,
I don't know if my last msg sent, I don't see it in my outbox.
I'm looking for 3 things:
One (the left) white Venturi straw the pushes in to the back of the steering nozzle.. Not the black tubes that snap into the top of the pump, but one of the white plastic straws that push in from the back...
The seadoopartswarehouse microfiche does not show them as available.

I also need a GOOD QUALITY rubber gasket that goes between the top and bottom airbox. Mines old and stretched

Lastly, I need a GOOD, NON LEAKING flush port that goes into the T Fitting so I can flush my ski.
Mine leaks s little water when flushing. It's old.

What's the price total and shipped to 34217? Looking to pay asap
Thanks! It's for a 96 spx

 

[Seadoobuddy]

Nick was the PWC final in AZ, i assume he was quite busy.
Give him a few days to get home and settled back in. I tagged him a couple times too and he hasn't replied yet.

 

[Spimothy Leary]

i have emails into tonka as well , didn't know he was out.

those flush fittings and airbox are all over ebay, cheap, especially if you can get someone to throw away the box and just send you the seal for $2 shipping

 

[96spxpos]

Yea., haven't heard from anyone but Spim, and it was ironic, his source was my old source, and I don't think the guy is hoarding anymore.
The parts are want aren't too expensive new, like that air box gasket is like $20.
Only problem is, that left Venturi straw that gets pushed in from the nozzle, the microfiche doesn't show/offer that part, so I don't know where to get it. (I pushed both in extremely snug when I serviced the pump, obviously the left one wasn't in tight enough!)
Other than that I'll buy the flush t and gasket new if no one responds by tomorrow morning.

I just need a source for that Venturi straw (the white one)
I looked online too and the only thing I found was the whole nozzle, used. I just need one tube. I'll even buy both if I have to buy the pair
Thanks

 

[96spxpos]

Yea Spim, I can get the gasket and flush t for cheap new, just can't find that straw

 

[96spxpos]

Does anyone know if my 96spx requires the "Rear drain" or NON-Rear drain" flush kit?
Trying to get it from SBT now, and it doesn't look like there's much of a difference. to flush mine, my current setup just has the upside down T and my hose connects to it and I crimp the back end of that hose while flushing.

Thanks!
its either this: http://www.shopsbt.com/mm5/merchant.mvc?Screen=PROD&Product_Code=sea-doo-flush-kit-rear-drain

or this: http://www.shopsbt.com/mm5/merchant...a-doo-flush-kit-quick-snap-all-non-rear-drain

then theres a LONG Rear drain one: http://www.shopsbt.com/mm5/merchant...oo-flush-kit-long-rear-drain-version-all-rear

 

[Minnetonka4me]

PM sent...

Sorry for the delay, just having the time of my life out in Havasu. Some important networking taking place....you know Teppanyaki and Saki with Hydroturf and Liquid Militia. Also talked with Fishetti for a few mins regarding starting a new circuit of racing up our way!! Stoked!

 

[Davidgsx]

Not trying to hijack but how late in the year can you ride at Havasu?


Sent from my iPhone using Tapatalk

 

[96spxpos]

Ahem... Umm..Havasu...
check this out... I almost actually get nauseous after about 3 minutes!
http://www.youtube.com/watch?v=qugiTaOh1cg

 

[Davidgsx]

Guy was making me dizzy! Did not tell me how late in the year the weather and water temps are good though


Sent from my iPhone using Tapatalk

 

[Minnetonka4me]

you can ride havasu year around by MN standards.

If you wanna check out all the coverage Ive posted, here is a link to my facebook page:

https://www.facebook.com/nick.cairns.7

and a shameless plug...

https://www.facebook.com/WestsidePowersports

 

[96spxpos]

Are these ok?

[MENTION=41828]Minnetonka4me[/MENTION] , sent u a PM yesterday after I called, never heard back..

The white straw is stock, the black is what Nick sent..

Although these aren't as long, will these still be ok, or will these being too short flood my hull from reverse leaking?

 

[TheMachin0]

are they the bilge tubes that connect to the pump and slide through the hull if so they are fine as long as the threads are the same and length is good

 

[Minnetonka4me]

Man you're impatient!! LOL

Again...as far as I know...these were the only replacements available that Seadoo made. If you find that they arent working let me know and Ill try to yank some out of the nozzle.

I forgot that airbox plug. With all orders...its highly advisable to put EXACTLY what you expect to get it in the notes on Paypal. Esp small stuff Im throwing in for free. Thats the last thing I see before I print a shipping label.

So let me know what you find on those tubes.

 

[96spxpos]

Lol no, it's just that I didn't think my PM was working still, so I decided to ask others instead of bothering you bro. Plus I've got a kitchen remodel going on, a fridge and stove delivery on my rental side, and a carpet stretching as well, so I was trying to get those straws in this morning.
And those paypal notes are neither here nor there, as I put my shipping address in the paypal notes where I wanted the parts to come, and they showed up at my home address..
Thanks for the parts and quick shipping though

The machine, no, they're the white tubes that you press in to the back of the steering nozzle. They press into those two drains that sit atop the pump housing.
They seem like they'll fit in snug in the holes, they're just not as long
Should I give em a try?

 

[Minnetonka4me]

I really think they will work fine, as I said thats what seadoo sold as replacements those are OEM parts out of a OEM bag.

My apologies on not getting that plug to ya...remind me on the next order. If it was something bigger I made you pay for Id have already sent it.

 

[96spxpos]

Excellent. I'm going to put them in. I'll let you know. Thanks bro!

 

[96spxpos]

I really think they will work fine, as I said thats what seadoo sold as replacements those are OEM parts out of a OEM bag.

My apologies on not getting that plug to ya...remind me on the next order. If it was something bigger I made you pay for Id have already sent it.

Sounds good, I may order 2 throttle cables from you. Do you have good used ones and new ones? How much for each?

 

[Minnetonka4me]

Ive got a few really nice used ones.. 2 for $45 shipped. No freys fresh water.

 

[96spxpos]

Ok. I found a NOS one for 30 plus shipping, and I need 2, so $45 sounds like a better deal for two.
I'm going to pick up the HX and see if it's just an adjustment or if I'll need a replacement and get 2 from you.
I'll let you know. Thanks