P1520 error code

[venera15]

Hi, i have a 2007 Seadoo Challenger 180SE, and i was hoping someone would help me figure out my problem. As soon as the boat reaches about 3000rpms starts beeping and gives a code for P1520 and check oil light comes up.
Read that it might be the oil pressure switch and i replaced it, but the issue still exists.

 

[KK40384]

which oil pressure switch did you replace? there's 2 if i remember correctly

 

[venera15]

part number 420856532.

I can't find where the other one would be?

 

[Michael211_2000]

Is that a boat or a PWC? You're only posting in the PWC forum here.

- Michael

 

[Dennis]

There is only 1 pressure switch on your engine and you have replaced it.You need to check oil pressure.

 

[venera15]

Dennis, how would i check oil pressure?

 

[Dennis]

You would remove the oil pressure switch (the one you replaced) and install a oil pressure gauge, start the engine and then see how much oil pressure you have.

Warm engine. You should have approx. 35 P.S.I. at idle and approx. 65 P.S.I. when revving the engine.

Has the engine injested water recently?

 

[MARTINGOMEZ65]

?someone got the solution to this problem?

Dennis, how would i check oil pressure?

someone got the solution to this problem?

 

[Coastiejoe]

someone got the solution to this problem?

As Dennis stated, get an oil pressure gauge and thread it in where the oil pressure switch is and read the pressure.

Unless I'm not understanding what you are asking?