floatingRyan
Member
So i stalled out on the water today. Limped it in as luckily it started and i was nowhere close to shore. Pull it up on shore and the hull has about 3 inches of water in it. I pull it up on the trailer, pull the plugs and turn it over. No water in the engine so yay. Start it on the trailer... it still starts yay. Take it home finish getting the water out of the hull and decide to flush it out. In doing this about half the water is blowing out of a little hole in the elbow of the exhaust. The hole is about half the size of pencil eraser. Reading old posts sounds like some have been able to use jb weld with success while the preference is to get it welded. Looks to be in a touch to reach spot so i may go with jb weld for now. Is there anything else i should be concerned with as far as water getti g into anything?
Last edited by a moderator: