k_24 Active Member May 19, 2018 #1 Im rebuilding 02 957 xp jet pump I used a c wise to push the bewrings in 1 bearing went in 1/8 more than it should Wen i put the rod back it it doesnt spin freely there is a lot of rubbing Is that normal? There is no grease or oil right now
Im rebuilding 02 957 xp jet pump I used a c wise to push the bewrings in 1 bearing went in 1/8 more than it should Wen i put the rod back it it doesnt spin freely there is a lot of rubbing Is that normal? There is no grease or oil right now
mikidymac Moderator Staff member Moderator May 20, 2018 #2 No, you have to set the bearing depth exactly as the manual states. This isn’t just a push them until they stop situation.
No, you have to set the bearing depth exactly as the manual states. This isn’t just a push them until they stop situation.
