• This site contains eBay affiliate links for which Sea-Doo Forum may be compensated.

Need help on exhaust cooling bypass waterline.

Status
Not open for further replies.

Cotton03

New Member
Put on a rear exhaust kit by RIVA and don't no where to put the line coming off the new exhaust I have a 05 RXT ..PLEASE HELP!!!!!!! EVERTHING is done but that one line where's it go...
 
The two rubber hoses between J-Pipe and Exhaust manifold, you will see the hose on the bottom has the nipple on it (Its a T fitting) connect one end of the hose to the nipple here, the other end should connect to your through hull port.

Make sense?
 
Mannnn yes i do thanx alot bmann i see what you are talking about after you said that i figured it out and once again thanx mann..........
 
Well to start off I got the X SC with 42lb injectors put the RIVA rear exhaust on it plus the RIVA grate w the RIVA block off kit, then a solars 14/19 prop and I'm putting on the fizzle 4inch intake kit as we speak then I'm going to fire it up because I havnt done that since I owned it because I just bought it about a mth ago and went straight to putting on parts...LOL I FIGURED IT SHOULD RUN ITS BUTT OFF I HOPE....
 
Well to start off I got the X SC with 42lb injectors put the RIVA rear exhaust on it plus the RIVA grate w the RIVA block off kit, then a solars 14/19 prop and I'm putting on the fizzle 4inch intake kit as we speak then I'm going to fire it up because I havnt done that since I owned it because I just bought it about a mth ago and went straight to putting on parts...LOL I FIGURED IT SHOULD RUN ITS BUTT OFF I HOPE....

You got a gps?
 
Ya I got one as soon as I get it on the water I will let u no what do u think its going to be around..
 
THAT WILL BE GREAT!!!!!!!!!!!!!I was thinking it was going to be about 68`69 but 71 i can handle that.........
 
Status
Not open for further replies.
Back
Top