1996 Challenger - I recently replaced the fuel selector valve/pet cock and in doing so, I needed to remove the control levers. I just lifted the whole assembly up and out of the way so I could disconnect the fuel lines to the fuel selector valve. Replaced it and now am stuck with the control lever assembly.
For the life of me, I can't figure out how to get it back in place. Is there a trick to this? I've tried dropping it in with the control lever in the forward position which seems to help, but as the unit gets close to the bottom, the whole assembly tilts to the right and just won't sit flush. I've been trying on and off for the past 2 days and can't get it to seat in place. Any advise would be greatly appreciated!
For the life of me, I can't figure out how to get it back in place. Is there a trick to this? I've tried dropping it in with the control lever in the forward position which seems to help, but as the unit gets close to the bottom, the whole assembly tilts to the right and just won't sit flush. I've been trying on and off for the past 2 days and can't get it to seat in place. Any advise would be greatly appreciated!