Code 0344

[cbever61]

Can't seam to clear this code ! Seminal power sports told me it was a bad cam shaft sensor so I replaced it and checked the wires and it still keeps coming back as active so if I run the ski up to 60 it will throw the code and go into limp mode and I remove the key and restart and it will run fine again but I still have the code. Any suggestions?

 

[Coastiejoe]

Did you solve this?

 

[cbever61]

Did you solve this?

No no matter what I do it just keeps coming back all new parts and it still won't go away I took it back to the mechanic to clear it again another $45 and within 5 minutes of ride time it came back again I can't understand it I have a new computer and new cam sensor

 

[Coastiejoe]

I'd have to open a manual, but many sensors have a removable part on the inside of the engine as well. If you KNOW your harness, sensor and MPEM are good, it may be internal.

If it were mine, I'd run a few extra ground wires to eliminate a potentially stupid issue. Extra grounds can never hurt, only help.

 

[Greg]

No no matter what I do it just keeps coming back all new parts and it still won't go away I took it back to the mechanic to clear it again another $45 and within 5 minutes of ride time it came back again I can't understand it I have a new computer and new cam sensor

I recommend getting a CanDooPro so you can do that yourself!