I was having an intermittent problem where I would loose spark and the XP would stop running and not start. Sometimes I would have a blown fuse in the box and it would fix it but then it would happen with fuses good and then fire again at another time. Then recently it died and will provide spark at all. No fuses, no self healing. In the service manual I see there is an adaptor needed to test the trigger coil. Is there a way around that? If I test for continuity between the yellow and white wire and the black and yellow wire, which per the wiring diagram go to the trigger coil, should I get continuity? I took the plug off the CDI module where the yellow and white wire goes in and tested the plug end of that wire to the ground in the box where the black with yellow wire mounts and did not get continuity.
I also see in the manual that the rev limiter can cause no spark condition. But the test for the rev limiter is done while the engine is running. Any other test for this part?
Any other suggestions on what to check for cause?
I also see in the manual that the rev limiter can cause no spark condition. But the test for the rev limiter is done while the engine is running. Any other test for this part?
Any other suggestions on what to check for cause?
Last edited: