Pwnage1337
Active Member
For any interested parties. I told myself I was going to turn on Three 6 Mafia and have that thing flipped over in 20 minutes. The video above is the result
Perfect. That's the answer I was looking for. I am going to sand this thing and hopefully spray tomorrow!!
even an orbital sander with an interface pad would do good in cutting down the majority of the material needed before he starts working on the finish.Inline sander is a blunt instrument. You will right through the gelcoat with that.
Inline sander is a blunt instrument. You will right through the gelcoat with that. Watch some videos to see how autobody techs color sand paint. Add some dish soap to your water to reduce friction. Stay away from high spots.
It's weird that you got all that orange peel. That should not have happened.
Tomorrow may be too early to sand.
probably your speedI'm not in doubt that my technique was wrong. In the areas of the keel where I laid on extra coats it is extremely smooth. I think my application was uneven
I am installing aftermarket sponsons with nylock nuts and a huge backer board so I have to remove foam.
Any tricks for aftermarket?