Pajamatime29
Member
Hi. New to the forum and just recently bought a new Seadoo. I have extensive experience on PWC’s however. Today, at exactly 9.0 hours on the engine I pushed the machine out into 4 feet of water, climbed on, started it and started moving. While idling in “F” (forward) I heard a loud beep and the engine light came on. The engine appeared to run fine and I didn’t notice any issues. Quickly returned to shore and checked over everything. I didn’t notice anything, oil was good, etc. Pushed the machine out once again, started it up, engine light was on for 2-4 seconds then disappeared. Machine ran fine for about 30-40 minutes after that. Started it 3 time’s and it didn’t skip a beat. When into the “codes” and code P0340 was displayed. This was the only code I got. Currently out camping and dealership is closed. Anyone have an idea what may have happened or if it’s a serious issue? Any advice would be greatly appreciated. I’m hoping a brand new machine that’s not even done break in doesn’t have any serious issues already!!!!! Thanks!