2000 rx will not take gas help !!!!

[gofastcrazy]

i bought it last week, i had to feather the throttle to get it out of the water.well i thought carbs,so i broke them down, rebuilt them the filters were stopped up bad. i replace everthing in the fule system, changed all the lines , main filter and rebuilt the carbs. it will still not take throttle from a dead start,it just bogs and cuts off. if you feather it will get on the water and run great at WOT ..whats next guys...... thanks p.s. i have not adjusted the high or low jets, and the motor is a stock 951

 

[daverade]

clean your rave valves?

 

[gofastcrazy]

did that too sorry forgot to put that in the post.

 

[Johnson8537]

did you check pop off pressure? maybe you need a carb rebuild?

 

[daverade]

hhhmmmmmm..if it were me, and i know this sounds dumb and like alot of work i would rebuild them again.... did you get ur idle screws back in the right position?

 

[gofastcrazy]

wjat shoule the low speed be adjusted to?

 

[daverade]

dunno have'nt gotten there yet... gonna do mine this weekend...got a shop manual? maybe somebody could chime in and let us both know!

 

[Dr Honda]

wjat shoule the low speed be adjusted to?

Low: 1-1/2 turns
High: 0


Personally, I'd check the accelerator pump. It probably isn't doing it's job.

 

[daverade]

if you have the 951 a guy posted this, this morning!!!
http://www.shopsbt.com/jetski/35-180-30.html

may help you out

 

[gofastcrazy]

Low: 1-1/2 turns
High: 0


Personally, I'd check the accelerator pump. It probably isn't doing it's job.

yea i thought that too but the accelerator pump is good to go. i forget which one is on the top side of the carbs the lows or high?