rebuild

So i picked up a 96 Challenger single 787 for next to nothing but I got a project on my hands.... So the previous owner has taken apart the Throttle/Shifter mechanism, i assume to replace a cable or something but he left it all apart. Does anyone have a good picture of how this thing is...

I just traded for a 93 SeaDoo XP that supposedly has "bad" carbs due to deteriorated fuel lines? Is this usually just a carb cleaning/rebuild or will it require more? I may have found a set of good carbs. Does the 1993 XP use the same carbs as the 1994 XP?

Rebuilding/Installing 951 motor. Not sure where this part belongs. Help needed.

I'm new to this forum because I'm new to PWC's. Just bought two at a 'could not believe' price, because I guess the engine needed to be replaced. The previous owner had run across a sandbar, tried to gun it off. It would not start after that. He even tried to flush out the sand, but the...

Hey guys, I have a complete top end rebuild kit for a 787 RFI. Its from WPS and has everything you need. The kit is .25mm oversize. I got it for my ski but the machine shop just told me I will have to get the next larger and I cant return this kit. $180.00 O.B.O

I have a 96 787 that I rebuilt top and bottom. I first built the motor with the same 82.25mm cylinder jugs (re-honed) and new pistons, rings, pins, bearings, & crank. I got about 5hrs into the break-in and I found compression was only 125/140. It ran ok, but I figured I would repair the...

Hello everyone. Frustrated newbie here. I recently purchased a 98 gtx limited, took it out to the lake first time, and it ran ok at low speed but died at high speed after a few mins. I took it to the shop for a tune-up, and went back days later, but it happened again. I found out about the...

Hi, The weather was finally nice enough here to get the boat out for a test run since the pump overhaul. FYI- I replaced: -floating ring (plus O-rings) -carbon ring -impeller (Solas 14/22) plus boot -wear ring -neoprene seal -pump shaft seal -pump oil I also resealed the ride...