• This site contains eBay affiliate links for which Sea-Doo Forum may be compensated.

Where to fog on 2002 GTI LE 717 rotax, pics included

Status
Not open for further replies.

gt2003

New Member
I found a great resource for putting antifreeze in my seadoo so thought the rest would be a breeze, lol! Here's my question, where do I fog? Here is what it looks like when I take off the seat

fog002.jpg


I took off the black cover and being a newbie thought I saw an air filter that needed to come off so I could fog the engine. WRONG! It isn't an air filter I think. It's more of a wire mesh screen. Here is what it looks like with the black cover off.

fog001.jpg


So, where do i fog?

Is that the spark arrestor in between the spark plugs? Is that what I need to fog through once I remove it?
 
Nevermind, I found it.

For those that may need to know and wander on to this thread, you see the little hole right in the middle of the black cover? That's where you fog the engine. Once that's done move onto the spark plugs and spray some fogging solution in each one, replace the plugs then turn over the engine a couple of times.
 
i was going to take the whole carb. system apart and do it that way for the gsx. i never noticed the black hole on mine. i guess ill have to look, thanks!
 
That "black hole" is supposed to have a rubber grommet in it

With a very small hole that is squeezed almost closed. The red straw on the XPS lube will push through the hole but water cannot get in. I leave the red straw in place. I spray XPS for 10-15 seconds while the motor is running. You should produce lots of smoke.
 
Status
Not open for further replies.
Back
Top