Tips or tricks to feed new wires thru the trailer...

[tturbonegro]

Got a wire and light kit...what's the easiest way to feed the worries thru from one end of the trailer to another? There must be a trick to push or pull them thru...?

 

[LouDoo]

Just tape the new wiring harness to the old wiring harness, pull the old wiring harness out, while pulling the new wiring harness in.

Lou

 

[Sink]

If the old wiring harness isn't there or the wires broke, use an electricians fish tape.

 

[ocod]

I used my measuring tape

 

[tturbonegro]

Thanks guys ! 3 responseces and 3 great suggestions for any situation !

 

[crisso]

if you have to feed any wires through conduit(pvc plastic)Tie some cloth to some string.longer than the conduit.make sure it loosly fits into the tube,but just a little bit tight.Now suck the other end with a shop-vac to pull the cloth and string thru.You now have a string pull-thru, for your wiring.This works in lots of different jobs.Hope it helps somebody

 

[Sink]

This also works with compressed air to blow it through.

 

[crisso]

Yep.It sure does

 

[John in Valley Forge]

Yes, but you have to go in the other direction.

 

[crisso]

Ha Ha .Not if you start at the other end

 

[Sink]

"Blow is just a figure of speach"..

(that's what SHE said)

 

[John in Valley Forge]

It all just depends on your point of view

 

[tturbonegro]

Thanks guys, was way easier than i thought...just connected them, taped them, and pulled em thru from font to back