• This site contains eBay affiliate links for which Sea-Doo Forum may be compensated.

Seadoo GTI155 wont start

Status
Not open for further replies.

kevmannb

New Member
Hi. I have a GTI 155 SE 2012 that al the sudden wont start. I put the key in and get the 2 beeps and nothing happens. You can hear a tick tick noise but that is it. It has 26 hours on it and says mainteince required. Any thoughts on what this might be. I have a appt with the dealership tomorrow to take a look at it.
 
Jump the solenoid. If it cranks, then the battery, cables and connections are good and it is something on the MPEM side of things (fuse, connection, start/stop switch, MPEM ect ect). If it does not crank, then you have a battery, cable, connection or starter issue. I am betting it is a battery or connection issue.
 
I just had this happen, the dealer says its common. The relay/fuse box can sweat, open the relay box and there should be a black little relay, pull it out and put it back in or replace if that doesnt work. My relay got stuck.
 
Problem is fixed now. There was some corrosion on the ground cable causing it not to start. Wiped the cable clean and applied a bit of grease. Good to go again :lol:
 
Status
Not open for further replies.
Back
Top