Hi,
My SeaDoo Challenger 2000 wont start in water (started fine before I launched it)
I’m getting 12.4v across the battery and 11.5v under load. The starter is turning the flywheel, but there are no rpms showing when I try to start the engine. Fire is going to the spark plugs. Low pressure fuel pump is clicking and providing suction, but I think the in-line filter is a bit blocked. Water-fuel separator is becoming pressurised but not filling with fuel. Spark plugs are not getting wet. There is a light on the water sensor near the computer module. I don’t know how to test if the lanyard stop is working or not, but it has always worked in the past.
Any advice on where to go from here would be great.
Thanks
Ben
My SeaDoo Challenger 2000 wont start in water (started fine before I launched it)
I’m getting 12.4v across the battery and 11.5v under load. The starter is turning the flywheel, but there are no rpms showing when I try to start the engine. Fire is going to the spark plugs. Low pressure fuel pump is clicking and providing suction, but I think the in-line filter is a bit blocked. Water-fuel separator is becoming pressurised but not filling with fuel. Spark plugs are not getting wet. There is a light on the water sensor near the computer module. I don’t know how to test if the lanyard stop is working or not, but it has always worked in the past.
Any advice on where to go from here would be great.
Thanks
Ben