• This site contains eBay affiliate links for which Sea-Doo Forum may be compensated.

Seadoo 1993 XP 657x hooking up fuel lines to carb

Status
Not open for further replies.

itsdone

New Member
Hi guys,

Since i lost my password to my old account i have to register under this new name.
Last year i drove with the car and my 2 seadoo's to spain (from the netherlands to spain) for the holidays.
Things went bad on vacation because my internal filter were fully clogged and on full throttle the engine cut off.. due the lack of fuel.

Now i've had a busy year on school and no time to repair my baby. Since the summer to spain is comming again i went replacing the fuel lines and internal filters and other stuff and i am almost done...

But here comes the thing.. I forgot which fuel line go's where.. i know, i know.. retard, but not really known with watercrafts at all. So i was wondering if anyone could hook me up with a picture of the carb on the cylinder where i can see the fuel lines.

If i aint mistaking, the pulse line go's to the engine.. the carb on the rear of the ski is the return line and the other carb is the in line. so i guess i did the right way, but just to make sure!

Thanks in advance.
 
Last edited by a moderator:
The fuel comes in to the front carb(it has the pump in it). The two inlets that face eachother get hooked together(orange). This feeds the rear carb. Then you a 1/4" line that is your fuel return to the tank.
 

Attachments

  • IMAG0126.jpg
    IMAG0126.jpg
    847.3 KB · Views: 60
Last edited by a moderator:
welllllll................

A pic isn't going to really show detail. You need to just open the service manual, and you will find a hose routing diagram.
 
Thanks for the response..

i've sorted it out by being plain simple.. follow the route that the carb normaly does and connect the lines.
the front carb is the in-line, the rear carb is the return line.. connecting both carbs with a short line and a line from the pulse to the engine itself and your done.

Thanks anyways:)
 
1994 Seadoo GTX I have a problem with getting gas to my engine I am wondering if my fuel hose are switched the front in line from the carburetor goes to what I have it connected to my fuel filter is that correct
 
If I unhook my inline from my carburetor does gas come out of the inline and is the n line connected to the fuel filter
 
Status
Not open for further replies.
Back
Top