Sea-Doo challenger 180 modified intake grate

Status
Not open for further replies.

Yoda1976

Premium Member
Premium Member
Looking to purchase a modified intake grate for a 2008 Sea-Doo challenger 180. Does anyone know it any company's make them for my boat, or a dyi to do it myself?

Thanks dave
 
Dave Since you have a challenger..Can I ask you a question?


This is my first boat and I was so excited to put it on the water this week but got a LOUD BEEP as soon as I started accelerating.
I've bought a CanDooPro and run a Report today.

I tells me 6 faults. 3 Ignition Coils, Oil level (i've just changed it 3 weeks ago and fill it up) as well as Fuel Pump and DESS line
I don't get any "TroubleShooting" suggestions from CanDooPro

THANK YOU VERY MUCH .IN ADVANCE!!

------------------

Occurred Faults

1)P0351 Ignition coil #1 open circuit or shorted to ground or to 12V (MAG coil on ETEC2)
2)P0352: Ignition coil #2 open circuit or shorted to ground or to 12V (PTO coil on ETEC2)
3)P0353 : Ignition coil #3 open circuit or shorted to ground or to 12V
4)P1520 Critical Low Oil Level Detected or No oil pressure detected
5)P0231 Fuel pump shorted to ground or open circuit or Fuel Pump relay signal pin shorted to ground
6)P1656 : DESS Post line shorted to Ground
---------------------------------
Vin Number: CEC1XXXXXXXX
Total Hours on MPEM or ECU: 144 Hours and 25 Minutes
Last Serviced By: 01748 Serviced on 140930
Last Service: 12 Hours 58 Min


VIDEO of the issue (Loud Beep)
https://goo.gl/photos/vBbkbvax6MHeqzHB8
 
Sounds like your voltage is dropped below save level. Check with meter if voltage regulator is charging. If not chrckbyour fuse for the voltage regulator
 
Status
Not open for further replies.
Back
Top