powerslave
Active Member
Does not say anything in the manual and can't find any discussion on it. The 2 O rings in the metal seal carrier need any grease on them or not? I didn't put any on but I can back peddle and put some on there if need be.
-
This site contains eBay affiliate links for which Sea-Doo Forum may be compensated.
Ring seal O rings need grease?
- Thread starter powerslave
- Start date
- Status
powerslave
Active Member
it's in my 96 gti
Dr Honda
Well-Known Member
You don't have a seal carrier in that ski.... but since it's "2 O-rings"... I'm going to assume that it's the stainless ring you are talking about??
If it is... you dont' need grease... but generally, you always lube O-rings before assembly. That way, you don't nick them while putting the parts together. BUT... if it's already on the drive shaft... don't worry about it.
If it's not together... wipe a little grease in it... then slide it on.
If it is... you dont' need grease... but generally, you always lube O-rings before assembly. That way, you don't nick them while putting the parts together. BUT... if it's already on the drive shaft... don't worry about it.
If it's not together... wipe a little grease in it... then slide it on.
powerslave
Active Member
OK, thanks. I swear on the parts diagram for my gti it says seal carrier for that part. diagram , that why I called it that. Thanks for the correction.
- Status
