• This site contains eBay affiliate links for which Sea-Doo Forum may be compensated.

ran then died & won't start

Status
Not open for further replies.

TFWildman112

New Member
so i took my jetski out today it's a 93 580 seadoo it was fine started up and ran through the no wake zone at idle then i went to give it gas and it had no power then died. it wouldn't run on "on" or "res" it doesn't have the grey lines anymore where should i start? oh and it has spark.
 
did you clean/replace fuel selector switch?
can you suck fuel from the "feed line" to the carbs?
do you have water in your front fuel fillter?
 
i can get fuel it just won't run new fuel and like i said i even pored it in the cylinders and nothing. there shouldn't be an issue.
 
it sounds like a spark issue then, have you checked that?

ya i've got spark. ok now i can get it to run on the trailer with the hose hooked up fine but when i put it in the water it starts hard will run for a min then die but then won't start. i think it's floodin cause i had to shut the gas off a few times to get it to run, but it runs good on the trailer just like crap in the water?
 
Last edited by a moderator:
Status
Not open for further replies.
Back
Top