Pump Vanes Broke, is it ok? Pics inside

[RebuiltSeadooBaffles]

Pulled my pump off to get some of the nickes on my impeller out with a dremel and noticed 2 of the vanes are broke, is it still ok? It did not seem like it was cavitating or pulling to one side at the lake when I tested it. I could smooth the vanes out with my dremel if it will work, also does the smoothing job I did on my prop look ok? Thanks.

 

[seadooya]

if the pump isn't acting up, go ahead and run it, unless you got a few buks left over, to throw at it...fwiw, my pumps' knarlier than that.

 

[Minnetonka4me]

If its a big hub pump like off a RFI, you might as well run it. Those are super hard to find, and quite expensive.

 

[RebuiltSeadooBaffles]

Would it effect my top speed at all?

 

[Minnetonka4me]

yes it would.

 

[jhjesse]

Would it effect my top speed at all?

If you are all about straight speed replace it. (boring)
Personally I'm about fun. I would smooth it up a bit with a dremel tool just to prevent additional cracking and run with it.

 

[RebuiltSeadooBaffles]

Will a pump that came out of a 2000 GTX 951 work on my 2000 XP?

 

[jhjesse]

Will a pump that came out of a 2000 GTX 951 work on my 2000 XP?

Yes :cheers: