• This site contains eBay affiliate links for which Sea-Doo Forum may be compensated.

Not sure what hose goes where???

Status
Not open for further replies.

new_found_power

New Member
I just put the engine back in my 2000 XP, got the driveline connected and the engine mounts bolted, but now I don't remember which hose goes where.

I have looked at the seadoo parts guide, but it doesn't go into detail. Does anyone have a pic of how the hoses go back on???
 
The "feed" hose coming from the jet pump, goes to the exhaust side of the cylinder head. If you have gray fuel lines to your carbs, you might think of replacing them in the future too as they deteriorate from the inside out and clog the carbs. You'll need to clean the carbs small internal filters as well.

Karl
 
I have one clear hose running from the back of the ski, it's down near the drive shaft, I have a bigger black hose up close to the sensor on the head, (maybe that one goes on the barb by the sensor?) I could have swore one of those gray hoses went to the head.
 
Status
Not open for further replies.
Back
Top