dothadoo
Active Member
I just bought a not so gently used 2002 RX, and the guy claimed it ran a little over a year ago and the carbs just needed to be cleaned out Bc it sat with fuel in it for that whole time. I have since removed the carburetor and am going to order a Mikuni rebuild kit. I do have a few questions about this particular ski though.
1. Does it have an electronic fuel pump that turns on when the ignition is turned on? If so, I don't hear it turning on and priming.
2. The oil line has been removed and has been converted to premix. I do get a low oil light on the dash and need to know how I can get it to turn off. Iirc, it will beep very annoyingly loud if it is not addressed. I suppose I could try adding oil, but I am not sure if the proper steps were taken when making the conversion.
3. There is a rubber shaft boot that is torn and I noticed a little zirk fitting on the flange. Do I just use a marine grease for this and how often should this be done?
Thanks for the help. I will likely have more questions as I get into the project a little further.
1. Does it have an electronic fuel pump that turns on when the ignition is turned on? If so, I don't hear it turning on and priming.
2. The oil line has been removed and has been converted to premix. I do get a low oil light on the dash and need to know how I can get it to turn off. Iirc, it will beep very annoyingly loud if it is not addressed. I suppose I could try adding oil, but I am not sure if the proper steps were taken when making the conversion.
3. There is a rubber shaft boot that is torn and I noticed a little zirk fitting on the flange. Do I just use a marine grease for this and how often should this be done?
Thanks for the help. I will likely have more questions as I get into the project a little further.
Last edited: