M2 Flywheel Cover - 2 pieces???

[rdradu]

Hi gang,
I took my flywheel cover off my 2001 Utopia, 200HP, to winterize my engine and it came off in two pieces (see pic's). This did not look right to me and think that these should be bonded together - am I correct in this? Any thoughts on how to correctly bond/glue these together?

TIA!

 

[rookie101]

Yeah, supposed to be one piece. The smaller tunnel directs air through the small filter to the air compressor for the injection system. Just grab some good silicone like 5200 or something with some holding power. If you can't find anything else, even pl400 construction adhesive would likely work fine. Lay a good bead along the edge of the smaller piece and let them dry for twenty four hours or so, should be fine.

Aaron