To make a long story short, I accidentally flushed both my 2017 and 2022 RXTX for about 2 minutes with the hose before starting the engines. Then ran each for 30 seconds with water flowing and then reved a couple times with the water disconnected. Should I change the plugs and oil or take them to the dealer? Given they started up am I ok? This was on Sunday. Soonest I can get back to them is Saturday.
-
This site contains eBay affiliate links for which Sea-Doo Forum may be compensated.
Flushed Without Engine Running
- Thread starter DE19930
- Start date
skiasylum
Well-Known Member
Since it ran after the incident probably no water in the cylinders and a little water won’t hurt the spark plugs. Water in the oil is no bueno. If there is water trapped in the intake or exhaust it will find its way to the oil. Check your oil quantity and quality on the dip stick. If no milky oil or increase in quantity run it on the hose for 2 to 3 minutes and check again. If it’s still good run it on the lake and check again. If the oil gets milky or the engine starts running rough there is water trapped in the exhaust or intake and they would need to be drained.
@skiasylum thank you for the help. I will check it out Saturday.
Similar threads
- Locked