• This site contains eBay affiliate links for which Sea-Doo Forum may be compensated.

97 GTI - Bogg at initial WOT

Status
Not open for further replies.

Radarscratch

New Member
Hey guys,

Well, been having some fun with the Seadoo's this year. Had them out a couple times and noticed that my GTI was bogging down at WOT from a stop. So, I went ahead and replaced all the gray fuel lines, cleaned up the fuel switch and sent the babies to the mechanic for carb overhauls.

Got them back and took them out this weekend. Both running great, except my 97 GTI is still bogging/hesitation at WOT from a stand still. So my question is, what causes this initial hesitation.

Thanks
B
 
If they were just rebuilt properly by someone else.... did you verify the high and low needle settings?

The bogging you are talking about, can be caused by the pop-off being too high, or the high speed check valve is leaking.

If it's not the low needle... the carbs need to come apart again to verify things.
 
Status
Not open for further replies.
Back
Top