• This site contains eBay affiliate links for which Sea-Doo Forum may be compensated.

96 Challenger787 Rotax misfiring - Help Please

Status
Not open for further replies.

Yooper Dooer

New Member
I am going to make this as short as I can.

Recently bought a 96 challenger. ran awesome in the water, I gave it full throttle and then it died but started right back up. After it started it was only running on one cylinder for the most part - by that I mean the dead side would kick or fire once or twice and then stop working again them fire and so forth - another words one cylinder misfires inconsistently...

The side that misses does have continuous spark and was recently taken apart to have piston rings replaced and a new base gasket.

I pulled the spark plug and it is wet compared to the other plug that is dry....

What Now??? I appreciate any help!!!

Thanks!!
 
That ignition fires both plugs together... so... either you have a "Leak" in the spark plug wire... or it can be rotten inside. We recommend removing the boot, and cutting the wire back about 1/4", and putting the boot back on. Also... the coil could be bad.
 
Status
Not open for further replies.
Back
Top